Weider Pro 8500 Smith Cage Bench English Manual - Page 17
Identify the Butterfly Cable 71.
View all Weider Pro 8500 Smith Cage Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
22. Attach the Foot Plate (9) to the Center Base (2) and the Backrest Upright (8) with 22 four M10 x 20mm Bolts (77) and four M10 Locknuts (79). See steps 4-9, 13, 15-17, and 19-21. Tighten all of the Bolts, Screws, and Locknuts used in these steps. 77 77 23. See the CABLE DIAGRAM on page 36 to identify the cables as you assemble them. 23 Note: Steps 23-45 are shown from the rear. Identify the Butterfly Cable (71). See the inset drawing. Orient one end of the Butterfly Cable (71) so that the flat side is facing downward as shown. Attach the end of the Butterfly Cable (71) to the Right Arm (11) with an M8 x 20mm Shoulder Bolt (85) and an M8 Locknut (78). Do not overtighten the Locknut; the Butterfly Cable must pivot easily. 24. Identify the V-pulleys (60), the 90mm Pulleys (not shown), and the 115mm Pulleys (not 24 shown). Route the Butterfly Cable (71) over a V-pulley (60). Attach the V-pulley, a Short Metal Cable Trap (61), and an M10 Washer (84) to the Backrest Upright (8) with an M10 x 60mm Bolt (88) and an M10 Locknut (79). Make sure that the Short Metal Cable Trap is oriented to hold the Butterfly Cable in the groove of the V-pulley. 79 8 2 79 79 9 85 71 78 11 71 Flat Side 71 84 88 61 60 79 8 17