Xerox 4400DT Service Manual - Page 256
on the Right Bearing. Remove the Right Bearing., RRP 4.1 MPT Chute Assembly
View all Xerox 4400DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 256 highlights
5. Remove the MPT Chute Assembly (RRP 4.1 MPT Chute Assembly on page 6-44). 6. Remove the Paper Handler Assembly (RRP 5.1 Paper Handler Assembly on page 6-57). 7. Remove the Registration Clutch (RRP 5.5 Registration Clutch on page 6-62). 8. Remove the two E-rings that secure the two Registration Gears as shown. 9. Remove the E-ring from the left end of the Metal Registration Shaft. 10.Release the two registration springs from the Metal Registration Roller. The left spring is gold-colored, and the right spring silver-colored. 11.Squeeze and hold the Upper Chute and Inlet Chute together. Align the hole in the chute with the tab on the Left Bearing. Remove the Left Bearing from the Metal Registration Roller. Note: Pay attention to the orientation of the Torsion Spring when removing the Right Bearing. 12.Lift the Torsion Spring and slide the Right Bearing out. Squeeze and hold the Upper Chute and Inlet Chute together and align the hole in the chute with the tab on the Right Bearing. Remove the Right Bearing. 13.Slide the Metal Registration Shaft to the right and remove the assembly. 14.Remove the left and right bearings from the Rubber Registration Roller. 15.Lift the right end of the Rubber Registration Roller and remove the roller. Registration Roller Phaser 4400 Laser Printer Service Manual 6-63