Xerox 4400DT Service Manual - Page 50

Error Message Summaries (cont'd.) Note: The messages listed in the "Diagnostic Message" column appear only in Service Diagnostics while printing Engine Test Prints. The code numbers in these messages also appear as part of the Help information displayed when you press i. Front Panel Diagnostic Message Message Error Description Troubleshooting Procedure Jam at Front; Open Front Cover to Clear. Press i. E3-1: Registration Jam Paper Late to Fuser sensor after arrival at Registration Sensor. Exit Sensor did not actuate within time after the Registration clutch is actuated. Open Front Cover. Remove Print Cartridge. Clear Paper Path. Go to Jam at Front; Open Front Cover to Clear. on page 2-23. E3-2: Registration Jam 1. Registration Sensor did not deactuate within time after actuation of Registration sensor. 2. Registration Sensor is actuated at power-on. Jam At Exit; Open Rear Cover To Clear. Press i. E4-0: Exit Jam E4-2: Exit Jam Paper leaves Exit Sensor early. 1. Paper late off Exit Sensor. 2. Exit Sensor on at power-on. Open Rear Cover. Clear Paper Path. Go to Jam At Exit; Open Rear Cover To Clear. on page 2-25. E4-3: Exit Jam Custom Paper late off Exit Sensor, exceeding the specified time from Registration Sensor. Open Rear Cover. Clear Paper Path. Change Paper Setting in Custom Mode to correct size. Go to Jam At Exit; Open Rear Cover To Clear. on page 2-25. Jam At Stacker; Open Both Rear Covers to Clear. Press i. E6-1: Stacker Jam E6-2: Stacker Jam 1. Paper late to Stacker Sensor. 1. Paper late off Stacker Sensor. 2. Stacker Sensor on at power-on. Open Stacker Rear Door. Clear Paper Path. Open Printer Rear Cover. Clear Paper Path. Go to Jam at Stacker; Open Both Rear Covers to Clear. on page 2-27. Phaser 4400 Laser Printer Service Manual 2-13