ZyXEL N220 User Guide - Page 29
Connecting to an AP Without Using WPS, 2.3.1 Manually Connecting to a Wireless LAN - network key
View all ZyXEL N220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 2 Tutorial 2.3 Connecting to an AP Without Using WPS There are three ways to connect the wireless client (the N220) to a network without using WPS. • Configure nothing and leave the wireless client to automatically scan for and connect to any available network that has no wireless security configured. • Manually connect to a network (see Section 2.3.1 on page 29). • Configure a profile to have the wireless client automatically connect to a specific network or peer computer (see Section 2.3.2 on page 31). 2.3.1 Manually Connecting to a Wireless LAN This example illustrates how to manually connect your wireless client to an access point (AP) configured for WPA-PSK security and connected to the Internet. Before you connect to the access point, you must know its Service Set IDentity (SSID) and WPA-PSK pre-shared key. In this example, the AP's SSID is "SSID_Example3" and its pre-shared key is "ThisismyWPA-PSKpre-sharedkey". After you install the ZyXEL utility and then insert the wireless client, follow the steps below to connect to a network using the Site Survey screen. 1 Open the ZyXEL utility and click the Site Survey tab to open the screen shown next. Figure 9 ZyXEL Utility: Site Survey 2 The wireless client automatically searches for available wireless networks. Click Scan if you want to search again. If no entry displays in the Available Network List, that means there is no wireless network available within range. Make sure the AP or peer computer is turned on, or move the wireless client closer to the AP or peer computer. See Table 4.4 on page 54 for detailed field descriptions. N220 User's Guide 29