ZyXEL Vantage Report 2.3 User Guide - Page 529

Chapter 13 Logs Table 227 Logs > Log Viewer > All Logs LABEL DESCRIPTION End Time Enter the time of the latest log entries you want to see, if you select Day. Days Select this if you want to look at log entries for a specific range of days. Start Date This field is enabled and required if you select Days. Enter the date of the earliest log entries you want to see. You cannot enter a date earlier than the number of previous days that you configured in the System Setting > General Configuration screen. You can also click the Calendar icon to specify the date. End Date This field is enabled and required if you select Days. Enter the date of the latest log entries you want to see. You cannot enter a date earlier than Start Date or later than today. You can also click the Calendar icon to specify the date. Category This field can vary according to which device the logs are collected for.Vantage Report. Severity Select what type of log entries you want to see. You can also select All Categories. This field depends on the logs received by Vantage Report from the selected ZyXEL device. Select what type of log entries you want to see. You can also select All. Severity ranking follows RFC 3164 of the SYSLOG protocol and is defined as follows. Reverse DNS Advanced Search Source IP Services Destination IP Protocol • Emergent - System is unusable • Alert - Action must be taken immediately • Critical - Critical conditions • Error - Error conditions • Warning - Warning conditions • Notice - Normal but significant condition • Info - Informational messages • Debug - Debug-level messages Select this to display logs with the domain name of hosts instead of their IP addresses. If you select this and Vantage Report does not find the domain name of a host, it will display the IP address. This feature might increase the amount of time it takes to display log entries, however. This field is disabled if Category is All Categories. Select this if you want to use other search criteria to look at log entries. Enter the source IP address in the event that generated the log entry. Select the service whose log entries you want to see. If you select [Custom Service], you have to specify the Protocol and Port too. Enter the destination IP address in the event that generated the log entry. This field is enabled if Services is [Custom Service]. Select the protocol whose log entries you want to see. Vantage Report User's Guide 529