ZyXEL Vantage Report 2.3 User Guide - Page 569

Chapter 14 System Setting Table 252 System Setting > Rule-based Alert > Add/Edit > CPU/Memory/Session Usage LABEL DESCRIPTION Second Alert after.. minutes Specify when you want Vantage Report to send a second e-mail notification. Enter the number of minutes between 1 to 60. Enter 0 to disable this. Third alert after.. minutes Specify when you want Vantage Report to send a third e-mail notification. Enter the number of minutes between 1 to 60. Enter 0 to disable this. Select Devices Check which devices the rule applies to. Click Select All if you want the conditions you set to be monitored for all devices. Notification Notification Choose Select a notification profile that applies to this rule. Click the Setting icon to take you to the System Setting > Notification screen (see Section 14.6 on page 561) for managing notification profiles. Apply Click this to add the rule or apply the edits to an existing rule. Reset Click this to leave all the fields blank or back to the original values if you are editing a previous configuration. Cancel Click this to go back to the Rule-Based Alert screen. 14.7.1.2 Port Usage Use this screen to configure an alert rule for port usage. Note: This condition filter only applies to the ZLD platform type. Click System Setting > Rule-based Alert then either click on the link of the existing Rule Name or click Add. Select Port Usage in the Condition field. The fields in the Filter section change to the following. Figure 273 System Setting > Rule-based Alert > Add/Edit > Port Usage The fields above are described in the following table. Table 253 System Setting > Rule-based Alert > Add/Edit > Port Usage LABEL DESCRIPTION Condition Select Port Usage in this field. Port Select which port in the device you want to monitor. Direction Select if you want to check outgoing (Tx) or incoming (Rx) traffic. You can also choose both (Tx+Rx). Vantage Report User's Guide 569