ZyXEL Vantage Report 2.3 User Guide - Page 614
IKE Logs continued
View all ZyXEL Vantage Report 2.3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 614 highlights
Appendix B ZyWALL USG Series and ZyWALL 1050 Log Descriptions Table 276 IKE Logs (continued) LOG MESSAGE DESCRIPTION [SA] : Tunnel [%s] Phase 1 key group mismatch %s is the tunnel name. When negotiating Phase-1, the DH group of the attribute list `attrs' did not match the security policy. [SA] : Tunnel [%s] Phase 1 negotiation mode mismatch %s is the tunnel name. When negotiating Phase-1, the negotiation mode did not match. [SA] : Tunnel [%s] %s is the tunnel name. When negotiating Phase-2, the Phase 2 authentication authentication algorithm did not match. algorithm mismatch [SA] : Tunnel [%s] Phase 2 encapsulation mismatch %s is the tunnel name. When negotiating Phase-2, the encapsulation did not match. [SA] : Tunnel [%s] Phase 2 encryption algorithm mismatch %s is the tunnel name. When negotiating Phase-2, the encryption algorithm did not match. [SA] : Tunnel [%s] Phase 2 pfs mismatch %s is the tunnel name. When negotiating Phase-2, the PFS specified did not match. [SA] : Tunnel [%s] Phase 2 pfs unsupported: %d %s is the tunnel name. When negotiating Phase-2, this device does not support the PFS specified. [SA] : Tunnel [%s] %s is the tunnel name. When negotiating Phase-2, the SA Phase 2 SA encapsulation did not match. encapsulation mismatch [SA] : Tunnel [%s] Phase 2 SA protocol mismatch %s is the tunnel name. When negotiating Phase-2, the SA protocol did not match. [SA] : Tunnel [%s] SA %s is the tunnel name. When negotiating Phase-2, the SA sequence size mismatch sequence size did not match. [XCHG] exchange type is not IP, AGGR, or INFO This device is the responder and this is the initiator's first packet, but exchange type is not IP, AGGR, or INFO and the packet is ignored. Cannot resolve My IP Addr %s for Tunnel [%s] 1st %s is my ip address. 2nd %s is the tunnel name. When selecting a matched proposal in phase-1, the engine could not get My-IP address. Cannot resolve Secure Gateway Addr %s for Tunnel [%s] 1st %s is my ip address. 2nd %s is the tunnel name; When selecting a matched proposal in phase-1, the engine could not get the correct secure gateway address. Could not dial dynamic %s is the tunnel name. The tunnel is a dynamic tunnel and tunnel "%s" the device cannot dial it. Could not dial %s is the tunnel name. The tunnel setting is not complete. incomplete tunnel "%s" Could not dial manual %s is the tunnel name. The manual key tunnel cannot be key tunnel "%s" dialed. DPD response with invalid ID When receiving a DPD response with invalid ID ignored. DPD response with no active request When receiving a DPD response with no active query. 614 Vantage Report User's Guide