3Com 3102 User Guide - Page 78
Do Not Disturb, If you specify r or VoiceMail for the first attempt
UPC - 662705506043
View all 3Com 3102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
78 CHAPTER 8: PERSONALIZING YOUR TELEPHONE Do Not Disturb Attempt 2 through 5 as 2 through 5 as Method Pager VoiceMail Notice Behavior ■ You receive a pager call for each voice message. ■ You receive a telephone call for each voice message. Follow the prompts to log in and listen to messages, or log in to the NBX NetSet utility. ■ If you specify Pager or VoiceMail for the first attempt: Attempt Method Effect 1 Pager or ■ You receive a telephone call or pager call for Voice Mail only the first new voice message.* and then you configure attempt: 2 through 5 as E-mail ■ You receive an e-mail notice for only the first new voice mail message.* The e-mail notice contains no information about the voice message (like time of receipt and number that called) and no WAV file attachment. 2 through 5 as Pager ■ You receive a pager call for only the first new voice message.* 2 through 5 as Voice Mail ■ You receive a telephone call for only the first new voice message.* *First new message means the first voice mail message that arrived at your mailbox since the last time that you logged in to your voice mailbox through a telephone OR through the NBX NetSet utility. Logging in restarts the cycle. Resetting the Off-Site Notification Cycle When you log in to your voice mailbox and hang up or log out (regardless of whether you listen to or delete messages), you start the off-site notification cycle again. You will be notified about the next message that comes into your voice mailbox. When the Do Not Disturb feature is enabled, calls coming in to your telephone immediately go to the call coverage point that you set in the NBX NetSet utility. See "Setting Your Call Coverage Point" in Chapter 7. You can ask your administrator to map the Do Not Disturb feature to an available Access button on your NBX Telephone, or you can use the Feature Code to enable and disable the feature.