Brother International CW-1000 Owners Manual - English - Page 119
Print, Payee, Amount, Splllout
View all Brother International CW-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
#xxxxx PRINT AREA OVER Data cannot fit in the print area. Press any key to move to the next screen. If you are printing checks using ( PA T): The Chech No. range input screen appears. If you are printing checks using (CHEcx): The Check No. input screen appears. If you are printing a report: The REPORT FORM IN? screen appears. If you are printing a label: The PRINT OUT? screen appears. When one of these screens appears, make sure that the check, report form, or label is not smaller than the specified size. (In particular, when printing checks, make sure you did not load personal checks instead of business checks.) If the size is incorrect, load paper of the correct size and try to print again. If you are printing checks and the size of the loaded checks is correct, press (CAN /C) and go to the SETUP mode to check and adjust the X position of each item, then try to print again. #xxxxx "DATE" TOO LONG One of the following messages may appear before printing a check. It means that the printing area for the indicated item is too short. #xxxxx Press any key to continue. "PAYEE" TOO LONG If you are printing checks using ( PTItap: The Check No. range input screen appears. #xxxxx "AMOUNT" TOO LONG If you are printing checks using (CRECK): The Check No. input screen appears. #xxxxx When one of these screens appears, press "SPLLLOUT" TOO LONG 11) and go to the SETUP mode to check and increase the width of the printing area for the #xxxxx item by reducing the value of X. Then try to print "MEMO" TOO LONG again. 113