Cisco 11503 Administration Guide - Page 103
Configuring Network Boot for a Passive SCM
UPC - 746320664958
View all Cisco 11503 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Chapter 2 Specifying the CSS Boot Configuration Booting the CSS from a Network Drive Configuring Network Boot for a Passive SCM To configure network boot for a passive SCM on the CSS 11503 or CSS 11506: 1. Configure an FTP record for the passive SCM, if not already configured (see the "Configuring a Boot Configuration Record for the Passive SCM" section). 2. Make sure the passive SCM management port has access to the network drive from which you are booting the CSS. If the primary SCM fails, the passive SCM connects to the remote disk and loads the software configuration. 3. Configure the CSS to boot from a network drive. For example: (config-boot)# passive primary boot-type boot-via-network bootrecord To display a list of configured FTP records, reenter the command and specify the ? character. For example: (config-boot)# passive primary boot-type boot-via-network bootrecord ? 4. Optionally, configure a primary configuration path to allow multiple CSSs to use the same boot image while keeping their configuration information in separate directories. Your FTP daemon must support the drive mapping. Also, the CSS must be able to access the configuration path through the FTP server as defined in the FTP record. For example: (config-boot)# primary config-path e:/adi_directory/ OL-5647-02 Cisco Content Services Switch Administration Guide 2-19