Cisco 11503 Administration Guide - Page 252

Configuring an RMON History Chapter 6 Configuring Remote Monitoring (RMON) Defining the Bucket Count You can define a bucket count, which is the number of discrete sampling intervals over which data is saved for a history entry. Use the requested-buckets count command to define a bucket count. The count variable is an integer from 1 to 65535. The default is 50. To define a bucket count of 25, enter: (config-rmonhistory[5])# requested-buckets 25 Defining the Bucket Interval You can specify the time interval, in seconds, to take a bucket sample for an RMON history operation. Use the interval value command to set this interval. Enter an integer from 1 to 3600 seconds. The default is 1800 (30 minutes). To define a time interval of 60 seconds, enter: (config-rmonhistory[5])# interval 60 Activating an RMON History Entry After you configure the history attributes, you can activate the history for the port. Use the active command to activate an RMON history entry. Before you activate the history, make sure you finish configuring it and are satisfied with the RMON history settings. After you activate a history, you cannot modify its configuration settings. The only way to change the history is to delete it, and then recreate it. Before activating this command, you must specify the owner of the RMON history entry. To activate the history, enter: (config-rmonhistory[5])# active 6-26 Cisco Content Services Switch Administration Guide OL-5647-02