Cisco 11503 Administration Guide - Page 199
Configuring SNMP Trap Source
UPC - 746320664958
View all Cisco 11503 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Chapter 5 Configuring Simple Network Management Protocol (SNMP) Defining the CSS as an SNMP Agent For example: (config)# snmp trap-host 172.16.3.6 sqalab1 snmpv2 To remove a specified trap host, enter: (config)# no snmp trap-host 172.16.3.6 Configuring SNMP Trap Source To set the Agent-Address field in the traps generated by the CSS, use the snmp trap-source command. This command applies only to SNMPv1 and does not apply to SNMPv2C. The syntax of this global configuration mode command is: snmp trap-source [egress-port|management |specified source_ip_address] The options and variable for this command are: • egress-port - Uses the VLAN circuit IP address configured on the egress port to set the Agent-Address field of the trap. You do not need to enter an IP address because the address is determined dynamically by the CSS. • management - Uses the Ethernet management port IP address to set the Agent-Address field of the trap. This option is available only on a Cisco 11500 series CSS. • specified source_ip_address - Allows you to enter the IP address to be used in the Agent-Address field of the traps. Enter the IP address in dotted-decimal notation (for example, 192.168.11.1) For example: (config)# snmp trap-source egress-port To return SNMP source traps to the default of the management port IP address, enter: (config)# no snmp trap-source OL-5647-02 Cisco Content Services Switch Administration Guide 5-17