Cisco 11503 Administration Guide - Page 263

Chapter 7 Using an XML Document to Configure the CSS Creating XML Code 4. Pay attention to mode hierarchy of the CLI commands in the XML file. Each mode has its own set of commands. Many of the modes have commands allowing you to access other related modes. If you enter a series of commands in the improper mode hierarchy, this will result in an XML file that fails to execute properly. As an example, the following commands configure an access control list (ACL): acl 98 clause 10 permit any any dest any apply circuit-(VLAN3) In another example, the following commands configure a CSS Ethernet interface: interface ethernet-6 bridge vlan 3 circuit VLAN3 ip address 10.10.104.1/16 5. Pay attention to the allowable CLI command conventions for syntax and variable argument in the XML file. If you enter an invalid or incomplete command, this will result in an XML file that fails to execute properly. Note For overview information on the CLI commands you can use in global configuration mode and its subordinate modes, refer to the Cisco Content Services Switch Command Reference, Chapter 2, "CLI Commands." OL-5647-02 Cisco Content Services Switch Administration Guide 7-3