Cisco 11503 Administration Guide - Page 176
portmap, show system-resources, monitor the available memory under
UPC - 746320664958
View all Cisco 11503 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Frequently Queried Log Messages Chapter 4 Using the CSS Logging Features Table 4-8 Cisco 11500 Series CSS Log Messages (continued) Log Message (sys.log: Subsystem Name, Level, and Message) portmapper Subsystem PORTMAPPER-5: PortUnmap no Port mapping found. publish Subsystem PUBLISH-1: Unable to allocate tree memory Cause and Resolution A source group is running out of portmappers. Use the portmap command to increase the portmappers on the source group so that the message does not appear, and users or services do not see a performance or network address translation problem. The CSS is looking for a segment of memory that is approximately 4150000 bytes and it cannot locate an available block of memory. In some cases, this message may be caused by a replication misconfiguration. Review the configuration and verify that it reflects what was intended. Verify that files are being replicated properly. If this message is seen with significantly smaller memory requests, the system memory may not sufficient in size to meet the requirements of the configuration. To isolate the issue, monitor the available memory under non-replication conditions to determine a baseline and then repeat this process while replicating to isolate this issue. Use the show system-resources command to view information about the installed and free memory in the CSS. To make additional memory available, reboot the CSS. 4-56 Cisco Content Services Switch Administration Guide OL-5647-02