Cisco 7912G Phone Guide - Page 36

Starting or Joining a Meet-Me Conference Call Meet-Me conferencing allows participants to join a conference by calling the conference number directly, rather than waiting for the conference initiator to call them. To start a Meet-Me conference, use the MeetMe softkey on your phone, then dial the Meet-Me phone number provided to you by your system administrator. To participate in a Meet-Me conference, dial the Meet-Me phone number at a specified time. Conference participants hear a busy tone if they call into the conference before the conference initiator has dialed in. Once the conference initiator has dialed in, the Meet-Me conference is established and can continue even if the conference initiator disconnects. If you want to... Then... Establish a Meet-Me conference Press NewCall or go off-hook and press more > MeetMe. Dial the Meet-Me conference number. (See your system administrator for a list of valid numbers.) Note: Remember to inform participants about the conference number, so they can dial in. However, participants will hear busy tone if they call the conference number before you have dialed in. Join a Meet-Me conference Dial the Meet-Me conference number provided by the Meet-Me conference initiator. You can join the conference only after the initiator has dialed in. End a Meet-Me conference Hang up or press EndCall. Forwarding Your Calls to Another Number You can use Call Forward All to redirect your incoming calls from your Cisco Unified IP Phone to another number. Tip Enter the Call Forward All target number exactly as you would need to dial it from your desk phone. For example, enter an access code such as 9 or the area code, if necessary. If you want to... Set up call forwarding from your phone Cancel call forwarding from your phone Then... Press more > CFwdAll and enter a target phone number. The screen displays "Forwarded to ." Press more > CFwdAll. The "Forwarded to " message disappears. 28 OL-8166-01