Compaq ProLiant CL380 Compaq ProLiant CL380 User Guide - Page 133
Installing a Processor Power Module, PPM with the tab in the PPM socket.
View all Compaq ProLiant CL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
4-46 Compaq ProLiant CL380 User Guide Installing a Processor Power Module IMPORTANT: The Processor Power Module (PPM) is keyed to ensure correct alignment. A notch in the bottom edge of the module, near the center, must align with a tab in the mounting bracket. The notch and tab will not line up if the module is turned the wrong way. To install a PPM, perform the following steps: 1. Align the key slot in the bottom edge of the Processor Power Module (PPM) with the tab in the PPM socket. 2. Insert the PPM straight into the PPM socket on the system board. 3. Press the module into the socket while pushing the latches inward until they snap into place . 1 2 Figure 4-49. Installing a PPM 4. Replace the server node in the system. NOTE: For detailed instructions on replacing a server node, see the "Replacing a Server Node" section earlier in this chapter. 5. Power on the server node and use the System Configuration Utility to reconfigure your system.