Compaq ProLiant CL380 Compaq ProLiant CL380 User Guide - Page 220
Compaq Hot-Plug Ultra2 and Ultra3 SCSI Hard Drive LED Indicators, Table G-5, LED Indicators
View all Compaq ProLiant CL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
G-6 Compaq ProLiant CL380 User Guide Compaq Hot-Plug Ultra2 and Ultra3 SCSI Hard Drive LED Indicators There are three LED indicators on the Ultra2 and Ultra3 SCSI hard drives. During the shared storage area initial power up all the LED indicators ( , , and ) on the hard drives turn on. LED indicators and remain lit until the Power-On Self-Test (POST) of the CR3500 RAID Controller completes. During initialization, the activity LED of a drive will blink as being accessed by the CR3500 RAID Controller. After the CR3500 RAID Controller initializes, the LED indicators that remain lit on the hard drives is dependent on the RAID configuration. If they are part of a RAID 0+1, 1, 4, or 5, then the fault LED turns Off and the online LED remains lit. If the hard drives are not part of a RAID set (JBOD, spare, or unconfigured), then all the LED indicators turn Off. If the fault LED remains lit after initialization, the drive has failed. The following figure shows the location of the status LED indicators on a Compaq hot-plug Ultra2 and Ultra3 SCSI hard drive. 1 2 3 Figure G-5. Identifying the hard drive status LED indicators Table G-5 Compaq Hot-Plug Ultra2 and Ultra3 SCSI Hard Drive LED Indicators Item Description Disk activity Disk online Failed or disk offline