Compaq ProLiant CL380 Compaq ProLiant CL380 User Guide - Page 151
Installing the Optional Hot-Plug Drive Cage
View all Compaq ProLiant CL380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
4-64 Compaq ProLiant CL380 User Guide Installing the Optional Hot-Plug Drive Cage Installing the optional 2 x 1-inch drive cage allows you use up to two additional 1-inch hot-plug Wide Ultra2 or Ultra3 drives in your ProLiant CL380 server. The standard Integrated Smart Array Controller in your server supports the drive cage and additional hot-plug drives. Figure 4-66 illustrates a ProLiant CL380 with the optional drives installed, with the corresponding SCSI IDs shown. Please refer to Appendix H, "SCSI ID Configurations" for more information on SCSI IDs. NOTE: When combining Ultra2 and Ultra3 hard drives, all of the drives are limited to response times no faster than the maximum burst rate of up to 80 MB/s on the Ultra2 SCSI bus, or the transfer rate of the slowest device in the array. NOTE: Refer to the previous sections on Removable media devices, in this chapter, to assist in this process. 9 10 11 12 13 14 1 3 0 2 1 3 0 2 Figure 4-66. ProLiant CL380 with optional drive cages and SCSI IDs shown 1. Remove the node from the system. NOTE: For information on removing a server node from the system, see "Removing a Server Node" section earlier in this chapter. 2. Remove the removable media trays from the node. NOTE: For information on removing the removable media trays from the node, see "Removing the Removable Media Tray" section earlier in this chapter.