D-Link DGS-3620-52P CLI Guide - Page 284
debug stp state, debug ospf
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 20-14 debug stp state Description This command is used to enable or disable the STP debug state. Format debug stp state [enable | disable] Parameters state - Specifies the STP debug state. enable - Enable the STP debug state. disable - Disable the STP debug state. Restrictions Only Administrator level users can issue this command. Example To configure the STP debug state to enable, and then disable the STP debug state: DGS-3620-28SC:admin# debug stp state enable Command: debug stp state enable Success. DGS-3620-28SC:admin# debug stp state disable Command: debug stp state disable Success. DGS-3620-28SC:admin# 20-15 debug ospf Description This command is used to enable or disable OSPF debug flags. Format debug ospf [neighbor_state_change | interface_state_change {dr_bdr_selection} | lsa {all | originating | installing | receiving | flooding} (1) | packet {all | receiving | sending} (1) | retransmission | spf {all | intra | inter | extern} (1) | timer | virtual_link | route | redistribution] state [enable | disable] 279