D-Link DGS-3620-52P CLI Guide - Page 488
create igmp_snooping multicast_vlan_group_profile
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 488 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide - Specify a range of ports to be configured. state - (Optional) Specify if the multicast VLAN for a chosen VLAN should be enabled or disabled. enable - Enable multicast VLAN for the chosen VLAN. disable - Disable multicast VLAN for the chosen VLAN. replace_source_ip - With the IGMP snooping function, the IGMP report packet sent by the host will be forwarded to the source port. Before forwarding of the packet, the source IP address in the join packet needs to be replaced by this IP address. If none is specified, the source IP address will use "0" IP address. - Enter the IP address here. remap_priority - Specify the remap priority here. - The remap priority value (0 to 7) to be associated with the data traffic to be forwarded on the multicast VLAN. none - If none is specified, the packet's original priority is used. The default setting is none. replace_priority - (Optional) Specify that the packet priority will be changed to the remap priority, but only if remap priority is set. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure an IGMP snooping multicast VLAN with the name "v1", make ports 1 and 3 members of the VLAN, and set the state to enable: DGS-3620-28SC:admin#config igmp_snooping multicast_vlan v1 add member_port 1,3 state enable Command: config igmp_snooping multicast_vlan v1 add member_port 1,3 state enable Success. DGS-3620-28SC:admin# 40-3 create igmp_snooping multicast_vlan_group_profile Description This command is used to create a multicast group profile. The profile name for IGMP snooping must be unique. Format create igmp_snooping multicast_vlan_group_profile Parameters - Specifies the multicast VLAN profile name. The maximum length is 32 characters. Restrictions Only Administrator, Operator and Power-User level users can issue this command. 483