D-Link DGS-3620-52P CLI Guide - Page 809

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide - Enter the IP interface name used here. This name can be up to 12 characters long. If no parameter is specified, the system will display all the PIM configurations of all IP interfaces. Restrictions None. Example To display PIM configurations of IP interface System: DGS-3620-28SC:admin# show pim Command: show pim PIM Global State : Enabled Last Hop SPT Switchover : Never Register Probe Time : 5 Register Suppression Time : 60 PIM Interface Table Designated Hello J/P Interface IP Address Router Interval Interval Mode State System 10.90.90.101/8 10.90.90.101 35 70 DM Enabled Total Entries : 1 DGS-3620-28SC:admin# 73-6 config pim cbsr Description This command is used to set the priority, hash mask length, and bootstrap period of the candidate bootstrap (C-BSR) router per interface. Format config pim cbsr [ipif {priority [-1 | ]} | hash_masklen | bootstrap_period ] Parameters ipif - Specifies the IP interface used for this configuration. - Enter the IP interface name used here. This name can be up to 12 characters long. priority - (Optional) Specifies to set the C-BSR priority. The lower value indicates lower priority. The default value is -1. Note that only one interface can be the C-BSR in one device. -1 - Specifies that the interface will be disable to be the BSR. - Enter the C-BSR priority value used here. This value must be between 0 and 255. hash_masklen - Enter a hash mask length, which will be used with the IP address of the 804