D-Link DGS-3620-52P CLI Guide - Page 868
config ptp transport protocol
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 868 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide is receiving the PTP event messages. Ports on peer-to-peer transparent clocks use the peer delay mechanism to calculate the propagation delay between PTP ports. An End-to-End Transparent Clock supports the use of an end-to-end delay measurement mechanism between the slave clock and the master clock. Ports on end-to-end transparent clocks are independent of propagation delay mechanisms. Format config ptp mode [boundary | p2p_transparent | e2e_transparent] Parameters boundary - Specifies the Switch as a Boundary Clock. p2p_transparent - Specifies the Switch as a Peer-to-Peer Transparent Clock. e2e_transparent - Specifies the Switch as an End-to-End Transparent Clock. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To specify the switch as a peer-to-peer transparent clock: DGS-3620-28SC:admin# config ptp mode p2p_transparent Command: config ptp mode p2p_transparent Success. DGS-3620-28SC:admin# 79-4 config ptp transport protocol Description This command is used to specify the transport protocol that will be used for the communication path. Format config ptp transport protocol [ethernet | udp] Parameters ethernet - Specifies the transport protocol of PTP as IEEE802.3 Ethernet. udp - Specifies the transport protocol of PTP as UDP over IPv4. Restrictions Only Administrator, Operator and Power-User level users can issue this command. 863