D-Link DWS-3250 Product Manual - Page 27
Site Requirements, Unpacking, Package Contents, Unpacking Essentials
UPC - 790069289996
View all D-Link DWS-3250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
DXS/DWS 3200 Series User Guide Site Requirements The device is placed on a table-top. Before installing the unit, verify that the location chosen for installation meets the following site requirements. • General - Ensure that the power supply is correctly installed. • Power - The unit is installed within 1.5 m (5 feet) of a grounded, easily accessible outlet 100-250 VAC, 50- 60 Hz. • Clearance - There is adequate frontal clearance for operator access. Allow clearance for cabling, power connections and ventilation. • Cabling - The cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcast amplifiers, power lines and fluorescent lighting fixtures. • Ambient Requirements - The ambient unit operating temperature range is 0 to 40ºC (32 to 104ºF) at a rel- ative humidity of up to 95%, non-condensing. Verify that water or moisture cannot enter the device casing. Unpacking This section contains information for unpacking the device, and includes the following topics: • Package Contents • Unpacking Essentials Package Contents While unpacking the device, ensure that the following items are included: • The device • Four rubber feet with adhesive backing • Rack kit • An AC power cable • Console RS-232 cable with DB-9 connector • Documentation CD Unpacking Essentials Note Before unpacking the device, inspect the package and report any evidence of damage immediately. To unpack the device perform the following: 1. It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground. An ESD strap is not supplied with the device. 2. Place the container on a clean flat surface and cut all straps securing the container. 3. Open the container. 4. Carefully remove the device from the container and place it on a secure and clean surface. 5. Remove all packing material. 6. Inspect the product for damage. Report any damage immediately. If any item is found missing or damaged, please contact your local D-Link reseller for replacement. Page 26