Dell Alienware Area-51 Threadripper Edition R7 Service Manual - Page 116
Removing the base panel, Prerequisites, Procedure
View all Dell Alienware Area-51 Threadripper Edition R7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
Removing the base panel WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Prerequisites 1 Remove the stability foot. 2 Remove the left and right side-panels. See "Removing the side panels". 3 Remove the battery case. 4 Remove the hard drive (HDD1). Procedure CAUTION: If the front bezel and rear bezel have been removed, place the chassis carefully on a flat surface to avoid damaging the I/O ports. 1 Remove the four screws (#6-32x6) that secure the base panel to the chassis. 2 Remove the three screws (#6-32x6) from inside, securing the base panel to the left side of the chassis. 116