Dell Alienware Area-51 Threadripper Edition R7 Service Manual - Page 26
Replacing the stability foot, Procedure
View all Dell Alienware Area-51 Threadripper Edition R7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Replacing the stability foot WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Procedure 1 Tilt the computer towards the front until the base is facing up. 2 Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws (#6-32x6). 26
Replacing the stability foot
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
in
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
.
Procedure
1
Tilt the computer towards the front until the base is facing up.
2
Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
26