Dell Alienware Area-51 Threadripper Edition R7 Service Manual - Page 58
Removing the graphics card, Prerequisites, Procedure
View all Dell Alienware Area-51 Threadripper Edition R7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Removing the graphics card WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Prerequisites 1 Remove the stability foot. 2 Remove the left and right side-panels. See "Removing the side panels". Procedure 1 Lay the chassis on the right side. Locate the graphics card on the system board. For more information on graphics card see "system-board components". 2 Disconnect the power cables from the graphics card. 3 Rotate and open the PCIE door. 4 Press and hold the securing tab on the clamp. 5 Pull the clamp up out from the bracket. NOTE: The location of the power supply connector (VGA1, VGA2, and VGA3) varies depending on the video card installed. 6 Press and hold the securing tab on the graphics-card connector, grasp the card by its top corner. 58