Dell Inspiron 530 Owner's Manual - Page 152
Installing a Media Card Reader, Metal Plate
UPC - 883685981020
View all Dell Inspiron 530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
NOTE: The location/connectors may vary depending on your system type. For more information, see "System Board Components" on page 110. 4 Disconnect the FlexBay USB cable and the power cable from the back of the Media Card Reader and from the internal USB connector on the system board (see "Inside View of Your Computer" on page 109). 5 Remove the two screws securing the Media Card Reader. 6 Slide the Media Card Reader out through the front of the computer. 7 If you are not reinstalling the Media Card Reader, replace the drive panel insert, as needed. 8 Replace the bezel (see "Replacing the Bezel" on page 137). 9 Replace the computer cover (see "Replacing the Computer Cover" on page 176). 10 Connect your computer and devices to electrical outlets, and then turn them on. Installing a Media Card Reader 1 Follow the procedures in "Before You Begin" on page 105. 2 Remove the computer cover (see "Removing the Computer Cover" on page 107). 3 Remove the bezel (see "Removing the Bezel" on page 136). 4 If this is a new card reader installation: • Remove the drive panel insert (see "Removing the FlexBay Break-Away Metal Plate" on page 149). • Remove the Media Card Reader from its packaging. 5 Gently slide the Media Card Reader into place in the FlexBay slot. 6 Align the screw holes in the Media Card Reader with the screw holes in the FlexBay. 7 Tighten the two screws to secure the Media Card Reader. NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected. 8 Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector on the system board (see "Inside View of Your Computer" on page 109). 152 Removing and Installing Parts