Denon AVR-3311CI Owners Manual - English - Page 12

Simple version Basic version STEP 4 Calculation STEP 5 Check STEP 6 Store ENGLISH Set up speakers (Audyssey® Auto Setup) Finish 11 On the STEP3 screen, use ui to select "Next 1 Calculation", and then press ENTER. Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined. AUTO SETUP AUDYSSEY AUTO SETUP STEP4 Calculation Now calculating... Please wait. MultEQ XT [4/6] 25% • Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected. The more connected speakers there are, the longer it takes to perform analysis. 12 Use ui to select the item you want to check, and then press ENTER. AUTO SETUP AUDYSSEY AUTO SETUP MultEQ XT STEP5 Check Check processing results. To proceed,press "Next" Spkr Config Check Distance Check Ch. Level Check Crossover Check [5/6] Next Store ENTER Enter Select item to check RETURN Cancel • Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers. • If you want to check another item, press RETURN. 13 Use ui to select "Next 1 Store" and then press ENTER. NOTE • If the result differs from the actual connection status, or if "Caution!" is displayed, see "Error messages" (vpage 10). Then carry out Audyssey Auto Setup again. • If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning. • If you change speaker positions or orientation, perform Audyssey Auto Setup again to find the optimal equalizer settings. 14 Select "Store" and then press ENTER. Save the measurement results. AUTO SETUP AUDYSSEY AUTO SETUP STEP6 Store Press "Store" to store calculation results. MultEQ XT [6/6] Store ENTER Enter RETURN Cancel Apply and store measurement result AUTO SETUP AUDYSSEY AUTO SETUP STEP6 Store Now storing... Please wait. MultEQ XT 25% [6/6] • Saving the results requires about 10 seconds. • If the measuring results are not to be saved, press RETURN. A message "Cancel Auto Setup?" will be displayed. Press o then select "Yes". All the measured Audyssey Auto Setup data will be erased. NOTE During saving of measurement results, be sure not to turn off the power. 15 Unplug the setup microphone from the unit's SETUP MIC jack. 16 Set Dynamic Volume™. AUTO SETUP AUDYSSEY AUTO SETUP Finish Storing complete. Auto Setup is now finished. Please unplug microphone. Turn on Dynamic Volume? Yes No MultEQ XT [6/6] ENTER Exit Turn Dynamic Volume on and exit Auto Setup • For details of Dynamic Volume settings, see page 76. nn When turning Dynamic Volume on Use o to select "Yes", and then press ENTER. • The unit automatically enters "Evening" mode. nn When turning Dynamic Volume off Use p to select "No", and then press ENTER. NOTE After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again. Advanced version Information Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu 9