Gateway 9315 Gateway 9315 Server User Guide - Page 57
Removing a CD or DVD drive
View all Gateway 9315 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Removing a CD or DVD drive To removing a CD or DVD drive: 1 Follow the instructions in "Preventing static electricity discharge" on page 37. Make sure that you turn off the server, then unplug the power cord and all other cables connected to the server. Caution The CD or DVD drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged. 2 Follow the instructions in "Opening the server case" on page 38. 3 Unlock the bezel (if necessary) and remove it by pulling it from the chassis. 4 Disconnect the 44-pin CD drive cable from the backplane. 5 Push in on the blue lever at the back of the drive carrier to release the drive carrier from the drive bay, then slide the drive carrier out through the front of the server. 6 Press down on the side of the drive carrier to release the drive from the carrier. 7 Disconnect the 44-pin CD drive cable from the back of the interposer board. 8 Remove the four screws securing the rails to the carrier, then remove the rails. 9 Remove the two screws securing the interposer board to the back of the CD or DVD drive, then remove the interposer board. 10 Follow the instructions in "Installing a CD or DVD drive" on page 50 if you are installing a new CD or DVD drive. - OR - Install a slim-line drive bay filler panel into the empty bay. 11 Reinstall the bezel, if required, by snapping it into place on the front of the chassis. 12 Follow the instructions in "Closing the server case" on page 39. 13 Reconnect all power cords and peripheral device cables, then turn on the server. 52 www.gateway.com