GE 60-806-95R-16Z Installation Instructions - Page 21

Note If you plan on connecting an alphanumeric touchpad to the programming touchpad header on the panel, do not connect it until after the panel is powered up. Refer to "Entering Programming Mode." 3. Check the phones on the premises for dial tone and the ability to dial out and make phone calls. If phones do not work correctly, check all wiring and correct where necessary. Proceed to the "Troubleshooting" section of this manual if problems persist. Connecting the AC Power Transformer The panel must be powered by a plug-in stepdown transformer that supplies 16.5 VAC, 25 VA (60-822 or 60-679-CN). Connect the power transformer to the panel as shown in Figure 18. ! Caution Do not plug in the power transformer at this time. The panel must be powered up using the sequence of steps described in the following section, "Power Up the Panel." 1 6 . 5 V A C Panel Terminals 1 2 Note Without AC power, shutdown will occur if battery voltage falls below 10.2 VDC. Figure 18. Connecting the Power Transformer Powering Up the Panel After installing SnapCards and wiring all devices to the panel, you are ready to apply AC and backup battery power to the panel. ¾ To power up the panel: 1. Connect the red and black battery leads (included with panel) to the lugs located in the upper- left area of the panel circuit board (see Figure 19). Black Backup Battery Connections Red Installing the System Red Black Battery Figure 19. Connecting the Backup Battery 2. Connect the battery leads to the battery terminals as shown. 3. Plug the transformer into an outlet that is not controlled by a switch or ground fault circuit interrupt (GFCI). Alphanumeric touchpads display SCANNING BUS DEVICES, then a date and time display. Fixed display touchpads briefly show all text, no text, BUS SCAN, then a time display. 16