HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 105

Chapter 2 A Commands action counter Send documentation comments to [email protected] action counter To specify setting or modifying a named counter when an Embedded Event Manager (EEM) applet is triggered, use the action counter command. To restore the default value to the counter, use the no form of the command. action number [.number2] counter name counter value val op {dec | inc | nop | set} no action number[.number2] counter name counter value val op {dec | inc | nop | set} Syntax Description number .number2 name counter value val op dec | inc | nop | set Number can be any number up to 16 digits. The range for number2 is from 0 to 9. The counter name can be any case-sensitive, alphanumeric string up to 32 characters. Specifies the value of the counter. The val can be an integer from 0 to 2147483647 or a substituted parameter. The following operations can be performed: •Dec-decrement the counter by the specified value. •Inc-increment the counter by the specified value. •Nop-Only print the specified value. •Set-set the counter to the specified value. Defaults None. Command Modes Embedded Event Manager mode. Command History Release NX-OS 4.1(3) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to set or modify the counter when the EEM counter applet is triggered: switch# configure terminal switch(config)# event manager applet counter-applet switch(config-applet)# action 2.0 counter name mycounter value 20 op switch(config-applet)# OL-18089-02, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 2-13