HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 715

Chapter 11 I Commands islb virtual-target name Send documentation comments to [email protected] islb virtual-target name To configure an iSLB virtual target and enter iSLB target configuration submode, use the islb virtual-target name command. To revert to the default values, use the no form of the command. islb virtual-target name name {all-initiator-permit | initiator {initiator-name permit | ip address {A.B.C.D permit | X:X:X::X permit}} | pWWN permit | revert-primary-port permit | trespass permit} islb virtual-target name name {no all-initiator-permit | no initiator {initiator-name permit | ip address {A.B.C.D permit | X:X:X::X permit}} | no pWWN permit | no revert-primary-port permit | no trespass permit} no islb virtual-target name name Syntax Description name all-initiator-permit initiator initiator-name permit ip address ip-address pWWN pwwn-id revert-primary-port trespass Specifies the virtual target name to be used. The minimum length is 16 bytes and the maximum length is 223 bytes. Configures all iSLB initiators to access the target. Configures the iSLB initiator to access the target. Specifies the initiator name. The minimum length is 16 bytes and the maximum length is 223 bytes. Permits access to the specified target. Specifies the initiator IP address. The format is A.B.C.D or X:X:X::X. Specifies the pWWN of the Fibre Channel target. The format is hh:hh:hh:hh:hh:hh:hh:hh. Reverts to the primary port when it becomes active again. Enables trespass support. Defaults Disabled. Command Modes Configuration mode. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines This command is used to configure a static target for access by iSLB initiators. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 11-109