HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1144

storage (DMM job configuration submode) Chapter 22 Show Commands Send documentation comments to [email protected] storage (DMM job configuration submode) To add a storage port to a DMM job, use the storage command in DMM job configuration submode. storage vsan vsan-id pwwn port-wwn {existing | new} Syntax Description vsan vsan-id pwwn port-wwn existing new Specifies the VSAN ID. The range is 1 to 4093. Specifies the world-wide name of the storage port. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number. Specifies a port on the existing storage. Specifies a port on the new storage. Defaults None. Command Modes DMM job configuration submode. Command History Release 3.2(1) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to add storage information to a DMM job: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# dmm module 3 job 1 create Started New DMM Job Configuration. Do not exit sub-mode until configuration is complete and committed switch(config-dmm-job)# storage vsan 3 pwwn 1d:22:3a:21:3c:44:3b:51 existing switch(config-dmm-job)# Related Commands Command show dmm ip-peer show dmm srvr-vt-login Description Displays job information. Enables DMM. 22-76 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x