HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 781

Chapter 14 L Commands logging logfile Send documentation comments to [email protected] logging logfile To set message logging for logfile, use the logging logfile command.To negate the previously issued command or to revert to factory defaults, use the no form of the command. logging logfile filename severity-level [size filesize] no logging logfile filename severity-level [size filesize] Syntax Description filename severity-level size filesize Specifies the log filename. Maximum length is 80 characters. Specifies the maximum severity of messages logged. The range is 0 to 7, where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is notify, 6 is informational, and 7 is debugging. Specifies the log file size. The range is 4096 to 4194304 bytes. Defaults None. Command Modes Configuration mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines The switch logs messages at or above the configured severity level. Examples The following example configures logging information for errors or events above a severity level of 3 (errors) to be logged in a file named ManagerLogFile. By configuring this limit, the file size is restricted to 3,000,000 bytes: switch# config terminal switch(config)# logging logfile ManagerLogFile 3 size 3000000 Related Commands Command show logging Description Displays logging configuration information. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 14-19