HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 503

Chapter 7 E Commands exit Send documentation comments to [email protected] exit To exit any configuration mode or close an active terminal session and terminate the EXEC, use the exit command at the system prompt. exit Syntax Description This command has no arguments or keywords. Defaults None. Command Modes EXEC and configuration modes. Command History Release 4.1(1b) 1.0(2) Modification Modified the command output. This command was introduced. Usage Guidelines Use the exit command at the EXEC levels to exit the EXEC mode. Use the exit command at the configuration level to return to privileged EXEC mode. Use the exit command in interface configuration mode to return to configuration mode. You also can press Ctrl-Z, or use the end command, from any configuration mode to return to EXEC mode. Note The exit command is associated with privilege level 0. If you configure AAA authorization for a privilege level greater than 0, this command will not be included in the command set for that privilege level. Examples The following example displays an exit from the submode: switch(config-port-monitor)# exit switch(config)# The following example displays an exit from the interface configuration mode for VRRP to return to the interface configuration mode. switch(config-if-vrrp)# exit switch(config-if)# The following example displays an exit from the interface configuration mode to return to the configuration mode. switch(config-if)# exit switch(config)# The following example shows how to exit an active session (log-out). OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 7-17