HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 162

channel-group Chapter 4 C Commands Send documentation comments to [email protected] channel-group To add a port to a PortChannel group, use the channel-group command. To remove a port, use the no form of the command. channel-group {port-channel number force} no channel-group {port-channel number force} Syntax Description port-channel number force Specifies the PortChannel number. The range is 1 to 256. Specifies the PortChannel to add a port using the force option. Defaults None. Command Modes Interface configuration mode. Command History Release NX-OS 4.1(3) 3.0(1) Modification Deleted auto keyword from the syntax description. This command was introduced. Usage Guidelines The auto mode support is not available after 4.x. To convert auto PortChannel to active mode PortChannel, use the port-channel persistent command. This command needs to be run on both sides of the auto Port Channel. Examples The following example shows how to add a port to the PortChannel: switch# config terminal switch(config)# interface fc 1/1 switch(config-if)# channel-group 2 force fc1/1 added to port-channel 2 and disabled please do the same operation on the switch at the other end of the port-channel, then do "no shutdown" at both end to bring them up switch(config-if)# Related Commands Command Description show interface port-channel Displays the PortChannel interface information. 4-22 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x