HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 835

Chapter 18 P Commands peer (DMM job configuration submode) Send documentation comments to [email protected] peer (DMM job configuration submode) To add peer SSM information to a job, use the peer command in DMM job configuration submode. To remove the peer SSM information from a job, use the no form of the command. peer ip-address no peer ip-address Syntax Description ip-address Specifies the peer SSM IP address. The format for the IP address is A.B.C.D. Defaults None. Command Modes DMM job configuration submode. Command History Release 3.2(1) Modification This command was introduced. Usage Guidelines In a dual-fabric topology, the migration job runs on an SSM in each fabric. The two SSMs exchange messages over the management IP network, so each SSM needs the IP address of the peer. Examples The following example shows how to add peer SSM information to a job: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# dmm module 3 job 1 create Started New DMM Job Configuration. Do not exit sub-mode until configuration is complete and committed switch(config-dmm-job)# peer 224.2.1.2 switch(config-dmm-job)# Related Commands Command show dmm job show dmm ip-peer Description Displays job information. Displays the IP peer of a DMM port. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 18-3