HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1179

Chapter 22 Show Commands show fcip Send documentation comments to [email protected] 6 46.1.1.2 3225 7 47.1.1.2 3225 The following example displays information for a specified FCIP profile: switch# show fcip profile 7 FCIP Profile 7 Internet Address is 47.1.1.2 (interface GigabitEthernet4/7) Listen Port is 3225 TCP parameters SACK is disabled PMTU discovery is enabled, reset timeout is 3600 sec Keep alive is 60 sec Minimum retransmission timeout is 300 ms Maximum number of re-transmissions is 4 Send buffer size is 0 KB Maximum allowed bandwidth is 1000000 kbps Minimum available bandwidth is 15000 kbps Estimated round trip time is 1000 usec The following example displays FCIP summary information: switch# show fcip summary sw172-22-46-223# show fcip summary Tun prof Eth-if peer-ip Status T W T Enc Comp Bandwidth rtt E A A max/min (us) 1 1 GE1/1 10.10.11.2 DOWN N N N N N 1000M/500M 1000 2 2 GE1/2 10.10.60.2 DOWN N N N N N 1000M/500M 1000 Table 22-4 describes the significant fields shown in the previous display. Table 22-4 show fcip summary Field Descriptions Field Tun prof Eth-if peer-ip Status TE WA TA Enc Bandwidth max/min rtt (us) Description Tunnel number for the row. For example, a number 1 indicates tunnel fcip1 and a number 2 indicates fcip2. Tunnel profile. Ethernet interface to which this tunnel is bound. IP address of the tunnel peer port on the far end of the tunnel. State of the tunnel (UP or DOWN). Tunnel operating in TE mode (Yes or No). Write acceleration enabled (Yes or No). Tape acceleration enabled (Yes or No). Encryption enabled (Yes or No). Maximum and minimum bandwidth configured in the profile to which this tunnel is bound. Round trip time (RTT) in microseconds. Related Commands Command fcip enable Description Configures FCIP parameters. OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 22-111