HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 529

Chapter 8 F Commands fcdroplatency Send documentation comments to [email protected] fcdroplatency To configure the network and switch FC drop latency time, use the fcdroplatency command in configuration mode. To disable the FC latency time, use the no form of the command. fcdroplatency {network milliseconds [vsan vsan-id] | switch milliseconds} no fcdroplatency {network milliseconds [vsan vsan-id] | switch milliseconds Syntax Description network milliseconds vsan vsan-id switch milliseconds Specifies network latency. The range is 500 to 60000. Specifies a VSAN ID. The range is 1 to 4093. Specifies switch latency. The range is 0 to 60000 milliseconds. Defaults 2000 millisecond network latency. 500 millisecond switch latency. Command Modes Configuration mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines None. Examples The following example shows how to configure the network latency to 5000 milliseconds: switch# config terminal switch(config)# switch(config)# fcdroplatency network 5000 switch(config)# The following example shows how to revert to the default network latency: switch(config)# no fcdroplatency network 5000 switch(config)# The following example shows how to configure the switch latency to 4000 milliseconds: switch(config)# fcdroplatency switch 4000 switch(config)# The following example shows how to revert to the default switch latency: switch(config)# no fcdroplatency switch 4000 switch(config)# OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 8-25