HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 334

Chapter 5 D Commands do Send documentation comments to [email protected] do Use the do command to execute an EXEC-level command from any configuration mode or submode. do command Syntax Description command Specifies the EXEC command to be executed. Defaults None. Command Modes All configuration modes. Command History Release 1.1(1) NX-OS 4.1(1b) NX-OS 4.1(1b) Modification This command was introduced. Added the command output for extended bbcredit interface. Added a note. Usage Guidelines Use this command to execute EXEC commands while configuring your switch. After the EXEC command is executed, the system returns to the mode from which you issued the do command. Note The receive bbcredit value reflects the extended bbcredit configuration. Extended bbcredit range for Vegas and ISOLA cards is 256-3500. Examples The following example shows how to execute the EXEC commands: switch(config)# port-monitor name cisco switch(config-port-monitor)# do switch(config-port-monitor)# The following example disables the terminal session-timeout command using the do command in configuration mode: switch(config)# do terminal session-timeout 0 switch(config)# The following example creates and enables the interface from configuration mode: switch(config)# int fc 3/1 switch(config-if)# no shut The following example shows how to receive the extended bbcredit interface: switch(config-if)# do show interface fc3/2 fc3/2 is trunking Hardware is Fiber Channel, SFP is short wave laser w/o OFC (SN) Port WWN is 20:82:00:05:30:00:2a:1e 5-42 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco NX-OS Release 4.x