HP Cisco MDS 9120 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 912

rlir preferred-cond fcid Chapter 20 R Commands Send documentation comments to [email protected] rlir preferred-cond fcid To specify a preferred host to receive Registered Link Incident Report (RLIR) frames, use the rlir preferred-cond fcid command in configuration mode. To remove a preferred host, use the no form of the command. rlir preferred-cond fcid fc-id vsan vsan-id no rlir preferred-cond fcid fc-id vsan vsan-id Syntax Description fcid fc-id vsan vsan-id Specifies the FC ID. The format is 0xhhhhhh. Specifies a VSAN ID. The range is 1 to 4093. Defaults By default, the MDS switch sends RLIR frames to one of the hosts in the VSAN with the register function set to "conditionally receive" if no hosts have the register function set to "always receive." Command Modes Configuration mode. Command History Release 3.0(3) Modification This command was introduced. Usage Guidelines The MDS switch sends RLIR frames to the preferred host only if it meets the following conditions: • No host in the VSAN is registered for RLIR with the registration function set to "always receive." If one or more hosts in the VSAN are registered as "always receive," then RLIR sends only to these hosts and not to the configured preferred host. • The preferred host is registered with the registration function set to "conditionally receive." Note If all registered hosts have the registration function set to "conditionally receive," then the preferred host receives the RLIR frames. You can specify only one RLIR preferred host per VSAN. Examples The following example specifies FC ID 0x654321 as the RLIR preferred host for VSAN 2. switch# config t switch(config)# rlir preferred-cond fcid 0x654321 vsan 2 The following example removes FC ID 0x654321 as the RLIR preferred host for VSAN 2. switch# config t switch(config)# no rlir preferred-cond fcid 0x654321 vsan 2 20-22 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x