HP Dc5000 HP Compaq Business Desktop dc5000 Series Service Reference Guide 2nd - Page 111
guide screws into the J-slots, then slide the drive toward the back of the drive cage until it locks - closer
UPC - 829160313740
View all HP Dc5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Removal and Replacement Procedures- Small Form Factor (SFF) Chassis ✎ When replacing the drive, transfer the four screws from the old drive to the new one. The screws take the place of drive rails. ✎ The guide screws on a 3.5-inch diskette drive 1 are placed closer together than on the hard drive 2. 9. Insert the rear screws of the hard drive 1 into the rear J-slots. Slide the drive 2 toward the back of the drive cage until the front screws are aligned with the front J-slots. Then lower the front of the drive. Continue to slide the drive all the way back until it locks into place. ✎ If replacing a diskette drive, all guide screws (front and rear) will line up on the J-slots. Insert the guide screws into the J-slots, then slide the drive toward the back of the drive cage until it locks into place. 10. Connect the power and data cables. 11. Make sure the drive cables are routed properly (Section 7.8.2, "Cable Routing"). 12. Rotate the drive cage to its original position. 13. Replace the front bezel and computer access panel. Service Reference Guide, dc5000 360201-002 7-17