HP Dc5000 HP Compaq Business Desktop dc5000 Series Service Reference Guide 2nd - Page 136
Run Computer Setup F10 Setup., CPU or Chassis - video controller
UPC - 829160313740
View all HP Dc5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
POST Error Messages POST Error Messages Screen Message 501-Display Adapter Failure Probable Cause Graphics display controller. 510-Splash Screen image corrupted 511-CPU, CPUA, or CPUB Fan not detected Splash Screen image has errors. Fan is not connected or may have malfunctioned. 512-Chassis, rear chassis, or front chassis fan not detected Fan is not connected, may have malfunctioned. 514-CPU or Chassis Fan not detected. 520-Single Monitor Configuration warning 601-Diskette Controller Error CPU fan is not connected or may have malfunctioned. Single monitor configuration with monitor attached to video port 2. Diskette controller circuitry or floppy drive circuitry incorrect. 602-Diskette Boot Record Error 605-Diskette Drive Type Error Diskette in drive A not bootable. Mismatch in drive type. 610-External Storage Device Failure External tape drive not connected. 611-Primary Floppy Port Address Assignment Conflict Configuration error. Recommended Action Reseat the graphics card (if applicable). Clear CMOS. Verify that the monitor is attached and turned on. Replace the graphics controller. Install latest version of ROMPaq to restore image. Reseat fan cable. Reseat the fan. Replace the fan. Reseat chassis, rear chassis, or front chassis fan cable. Reseat chassis, rear chassis, or front chassis fan. Replace chassis, rear chassis, or front chassis fan. Reseat CPU or chassis fan. Replace CPU or chassis fan. Turn off unit, attach monitor to video port 1, then restart unit. Run Computer Setup (F10 Setup). Check and/or replace cables. Clear CMOS. Replace diskette drive. Replace the system board. Replace the diskette. Run Computer Setup (F10 Setup). Disconnect any other diskette controller devices (tape drives). Clear CMOS. Reinstall tape drive or press F1 and allow system to reconfigure without the drive. Run Computer Setup (F10 Setup). Remove expansion cards. Clear CMOS. C-4 360201-002 Service Reference Guide, dc5000