HP ProLiant SL270s HP Insight Remote Support and Insight Online Setup Guide fo - Page 35

B Using the Agentless Management Service iLO 4 Agentless Management uses out-of-band communication for increased security and stability. With Agentless Management, health monitoring and alerting is built into the system and begins working the moment a power cord is connected to the server. This feature runs on the iLO hardware, independent of the operating system and processor. The separately installed AMS collects additional operating system data. For a comparison of the information provided by Agentless Management and the Insight Management Agents, see Table 3 (page 35). Table 3 Information provided by Agentless Management and Insight Management Agents Component Server health Insight Management Agents • Fans • Temperatures • Power supplies • Memory • CPU Agentless Management with AMS • Fans • Temperatures • Power supplies • Memory • CPU Storage • Smart Array • HBA • Fibre Channel and iSCSI • SMART Drive Monitoring • Tape • External storage • Smart Array • HBA • SMART Drive Monitoring • Internal hard drives attached to Smart Array NIC • Standup and embedded • Standup and embedded • MAC and IP address • MAC and IP address • Link Up/Down • Link Up/Down traps • Teaming information • VLAN information Other • Operating system information (Host • iLO data MIB) • Operating system information (Host • iLO data MIB) • Performance data • Firmware inventory • Configurable thresholds • Driver/Service inventory • Logging events to operating system logs • Clustering information Verifying AMS installation Use the following procedures to verify the AMS installation: Verifying AMS installation: Windows To verify that AMS is enabled on a Windows system: 1. Open the Windows Control Panel. If the Agentless Management Control Panel is present, then AMS is installed. 2. Open the Agentless Management Control Panel. Verifying AMS installation 35