HP Scitex LX850 HP Scitex LX850 & LX820 Printers: Maintenance and troubles - Page 26
Method, Step and Repeat, Fit Substrate width, Center
View all HP Scitex LX850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
troubleshooting guide). If required, perform the Printhead alignment and recheck that the Printheads are aligned. 1. Browse to the following directory: C:/users/currentlogin/Documents/HP IPS/Substrate Creation. Printer calibration 2. Select the file 'Test1_temp_profile'. 3. Click on Open and set the following settings on this job: ● Set the printmode to the one that you plan to use, set also the correct substrate preset that you want to print on. ● In Method, select Step and Repeat. ● Check Fit Substrate width. ● Check Center. ● Increase the copies to reach a total length to print of at least 1 meters (40"). Here is an example: 20 Chapter 3 Printer calibration ENWW
troubleshooting guide). If required, perform the Printhead alignment and recheck that the Printheads are
aligned.
1.
Browse to the following directory: C:/users/currentlogin/Documents/HP IPS/Substrate Creation.
2.
Select the file ‘Test1_temp_profile’.
3.
Click on Open and set the following settings on this job:
●
Set the printmode to the one that you plan to use, set also the correct substrate preset that you
want to print on.
●
In
Method
, select
Step and Repeat
.
●
Check
Fit Substrate width
.
●
Check
Center
.
●
Increase the copies to reach a total length to print of at least 1 meters (40”).
Here is an example:
20
Chapter 3
Printer calibration
ENWW
Printer calibration