HP StorageWorks 6000 HP StorageWorks 6000-series Virtual Library System User G - Page 204

• Edit the Fibre Channel host port settings • Enable oversubscription and view oversubscription settings • View LUN mapping • Create, view, and destroy virtual libraries, tape drives, or cartridges • Add, view, or remove barcode templates Table 9 CLI configuration commands Command addNode discoverArray updateFC Usage 1 Add a node to the VLS. See getNodeNames. Discovers any new arrays added to the VLS. Changes the default FC host port connection settings. Where the options are: -a - ID number of node to modify (0, ...) (optional) -i - FC index (0, 1, ...) (required) -l - If attached in arbitrated loop mode, specifies a hard ALPA value between 0 and 125. A value of -1 specifies a dynamically assigned ALPA. If not attached to an arbitrated loop, this parameter is ignored (required) -r - Port number of the FC port to modify (required) -s - Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten GB) (required) -t - Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public Loop) (required) -h - Displays command usage information (optional) setOverSubscription Enables or disables oversubscription and specifies the percent storage remaining for notification. Where the options are: -e - Enable/disable oversubscription (0-Disabled or 1-Enabled) (required) -p - Percentage of capacity remaining for alert notification (required) -h - Displays command usage information (optional) Returns whether the oversubscription feature is enabled or disabled and the capagetOverSubscription city remaining percentage for notification alert. Oversubscription is enabled when enabled = 0. Oversubscription is disabled when enabled = 1. getLibTypes Returns a list of available library emulation types. Displays each library emulation's name, type, product, revision, and vendor information. Where the options are: -l - List only licensed types (optional) -h - Displays command usage information (optional) 204 CLI Command Set