HP StorageWorks 6000 HP StorageWorks 6000-series Virtual Library System User G - Page 50

1. Use the 2U rack mounting template as a guide to indicate where on the rack the rails for the disk array are to be mounted. a. At the front of the rack, with the front of the template facing you, align the lower edge of the template with the bottom of the rack (or the top of the previous rack component). Be sure that the lower edge of the template is level. b. Push the template tabs into the holes in the rack uprights to hold the template in place. Figure 21 Positioning the rack mounting template . c. Use a permanent marker pen to indicate the holes in the rack uprights into which the scissor-like locking latches are to be inserted, as specified by the template. d. Repeat these steps to mark the back of the rack, using the information on the back of the template as a guide to the required location of the locking latches in this case. WARNING! The pins in the rails are load-bearing. Do not remove the pins except to replace them with the pins for round-hole racks. 2. If the holes in the rack uprights are round instead of square, remove the standard pins from the rails and replace them with the round-hole pins provided in the rack mounting hardware kit. 3. Identify the left (L) and right (R) rack rails by markings stamped into the rails. 50 Hardware Installation