HP StorageWorks 8/80 HP StorageWorks 8-Gb SAN Switch hardware reference manual - Page 45
Cabling and configuring the SAN Switch
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
1. Insert the switch with the attached inner rails into the outer rails. NOTE: This step applies to installing a switch in HP 9000 Series, HP 10000 Series, or HP System/e racks. 2. Insert the device into the rack, and install one #10-32 x 1/2-inch Phillips pan-head screw with captive star lock washer. Repeat for the remaining side. See Figure 19 and Figure 20. Figure 19 Securing the switch (HP 9000 Series or HP 10000 Series Racks) Figure 20 Securing the device in an HP System/e Rack 3. Tighten the hex nuts installed in Step 4, page 40. See Figure 13, page 40. This completes the rack mount procedure. Cabling and configuring the SAN Switch The SAN Switch must be configured to ensure correct operation with a network and fabric. For instructions on configuring the switch to operate in a fabric containing switches from other vendors, see the HP StorageWorks Fabric OS administrator guide. 8-Gb SAN Switch hardware reference manual 45