HP rp5400 Installation Guide, Third Edition - HP rp5400 Family of Servers - Page 38

Step 2., Lifting Device

Get HP rp5400 PDF manuals and user guides View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Server Unpacking and Installation Receive and Unpack A Non-Integrated Server Step 2. If you are moving the server manually, use three people to lift the server from the packing material and pallet. Carefully move the server to the selected location. Step 3. If you are moving the server by an approved lifting device (such as Genie Lift Ô), remove the tear flap from the front lip of the carton bottom to allow access to the server, as illustrated below. Removal of the tear flap will reveal a slot between the bottom of the server and the inside bottom of the cardboard box. Step 4. Carefully raise the lift's platform so that it will slide into the slot located under the center of the server, but over the top of the pallet. Lifting Device Platform NOTE The server's center of gravity will vary with the hardware configuration, but it is generally located slightly behind the middle of the server. 38 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
Server Unpacking and Installation
Receive and Unpack A Non-Integrated Server
Chapter 2
38
Step 2.
If you are moving the server manually, use three people to lift the server from the packing material
and pallet. Carefully move the server to the selected location.
Step 3.
If you are moving the server by an approved lifting device (such as Genie Lift
±
), remove the tear
flap from the front lip of the carton bottom to allow access to the server, as illustrated below.
Removal of the tear flap will reveal a slot between the bottom of the server and the inside bottom of
the cardboard box.
Step 4.
Carefully raise the lift’s platform so that it will slide into the slot located
under
the center of the
server, but
over
the top of the pallet.
NOTE
The server’s center of gravity will vary with the hardware configuration, but it is
generally located slightly behind the middle of the server.
Lifting Device
Platform