HP rp5400 Installation Guide, Third Edition - HP rp5400 Family of Servers - Page 61
HP 700 Series System Console Configuration, HP700 VT-100 Mode Configuration
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Cabling and Power-Up Configure System Consoles HP 700 Series System Console Configuration The following describes the steps required to configure the HP 700 series terminal for VT-100 mode for operation with an rp54xx Server. Although any terminal capable of operating in VT-100 mode can be used, the HP700 series terminal is used here as an example because it is fairly common and it's configuration is typical of many terminals currently in use. HP700 VT-100 Mode Configuration The following procedure outlines the steps to configure the HP700 series terminal for VT100 operation. NOTE You may use either the arrow keys or the tab key to move between the setting options on the screen. 1. Press config keys function key. f8 2. Press terminal config function key. f5 3. Move to Terminal ID and enter "vt100". 4. Move to Set TermMode and, using the Prev and Next keys, select "EM100". 5. Press the config keys function key. f8 6. Press the ansi config function key. f6 7. Move to "multipage" and, using the Prev and Next keys, select "yes". (Enables screen scrolling). 8. Move to Backspace Del and, using the Prev and Next keys, select "Backspace/Del". 9. Move to EM100 ID and, using the Prev and Next keys, select "EM100". Configure the Asynchronous Values of the GSP After the ASCII console has been configured and physical connections made, make any necessary changes to the asynchronous values of the GSP. 1. Access the GSP with the ctrl+b entry. The GSP will respond with a GSP> prompt. 2. At the GSP prompt, enter the Configure Asynchronous (ca) command: The ca command will start a series of prompts. Respond to each prompt with the appropriate information. Example 3-1 CA command Leaving Console Mode - you may lose write access. When Console Mode returns, type ^E cf to get console write access. GSP Host Name: fesrhapgsp GSP> ca CA This command allows you to modify the local and remote modem serial portconfigura tions. Current configuration settings: Chapter 3 61